How to Ventilate Your Home When Outside Air Is Worse Than Inside
By late November, AQI readings across Delhi, Kanpur, and Ludhiana routinely cross 300. At that level, opening a window for cross-ventilation, the advice that works perfectly well in June, pulls particulate matter straight into the room you just cleaned. The instinct to seal the house is understandable. It is also only half a solution, because a sealed home builds up its own problems: carbon dioxide from breathing, moisture from cooking and bathing, volatile compounds off-gassing from furniture and cleaning products. The question is not whether to ventilate. It is when and how.
Read the AQI before you touch a window
The Central Pollution Control Board's SAMEER app and the IQAir website both give hourly AQI readings for most North Indian cities. The number that matters for ventilation decisions is PM2.5, not the composite AQI score, because PM2.5 is the fraction small enough to reach the lungs. Below 100 on the PM2.5 scale, short-burst ventilation, ten to fifteen minutes, is reasonable. Between 100 and 150, limit it to early morning, typically between 5 and 7 a.m., when traffic has not yet built and the temperature inversion from the previous night is starting to lift. Above 150, keep windows closed and rely on filtration instead. The pattern in most North Indian cities is that the worst readings cluster between 8 a.m. and 10 a.m. as traffic peaks, and again after 10 p.m. as temperatures drop and pollutants settle closer to ground level. The cleanest window, if there is one, is usually just before dawn.
Stack ventilation: let physics move the air
When conditions do allow a window open, cross-ventilation is more effective than opening a single window and hoping. Open a low inlet on the windward side of the house, whichever wall faces the prevailing breeze, and a high outlet on the opposite side. Warm, stale air rises and exits through the high opening while cooler outside air enters low. In a North Indian winter this works even with a small temperature differential. If your flat has no through-flow because all windows face one direction, open the main window slightly and crack the bathroom exhaust vent or kitchen chimney flap on the other side. The exhaust fan running on low creates a mild negative pressure that pulls fresh air in through the smaller gap. This reduces the volume of outside air entering while still cycling the indoor air.
Filtration when ventilation is not possible
A room-size HEPA air purifier running continuously does measurably reduce PM2.5 indoors when windows are closed. The key variable is CADR, Clean Air Delivery Rate, matched to the room's volume. A rough rule: multiply the room's square footage by the ceiling height in feet to get cubic feet, then choose a purifier whose CADR in cubic feet per minute is at least two-thirds of that number. For a 150-square-foot bedroom with a 9-foot ceiling, that is roughly 900 cubic feet, so a CADR of 600 or above. Running it on high continuously is noisier and uses more electricity; running it on medium continuously is nearly as effective for steady-state pollution and quieter enough to sleep through. Replace filters on the manufacturer's schedule. A clogged HEPA filter stops being a filter and becomes a surface that re-releases captured particles.
Manage the indoor sources you control
Outdoor PM2.5 gets most of the attention, but indoor sources compound the problem in a sealed home. Cooking on a gas stove generates nitrogen dioxide and PM2.5 directly. Running the kitchen chimney on high while cooking and for five minutes after is one of the single most effective things you can do for indoor air quality, more effective, per unit of effort, than most other interventions. Incense, dhoop, and agarbatti generate fine particulate matter at concentrations that can exceed outdoor smog levels in a small room. If they are part of a daily practice, burn them near an open window or in a room that can be temporarily isolated and then aired out during a clean-air window. Wet mopping over dry sweeping reduces resuspension of settled dust. A damp mop picks up particles that a broom lifts back into the air.
Seal the gaps that matter, leave the rest
Not all gaps are equal. The gaps worth sealing are those that connect directly to high-pollution outdoor zones: the gap under the front door if it faces a busy road, the gap around window air conditioner units that are not in use, and the gap where utility pipes enter through exterior walls. Foam weatherstripping on door bottoms and AC unit covers cost under a few hundred rupees and make a measurable difference. The gaps not worth obsessing over are small cracks in older plaster walls, which exchange air so slowly they contribute almost nothing to PM2.5 infiltration. Sealing a house completely is also not achievable in most Indian residential construction, and chasing every crack wastes effort that would be better spent on filtration and source control.